Restore the dull plastic trim parts to its former glory. OVERcoat Final Touch TRIM penetrates deep into the resin to restore the original color and also provides protection against aggressive environmental factors. With a large quantity of 100ml.


Large Capacity

OVERcoat Final Touch TRIM has various effects, a large capacity of 100ml (3.38oz), being the most cost-effective product among trim coating agents.

How To Use

Trim Coating Application

STEP 1 Make sure the surface of the plastic trim part is clean and free of any residue such as dust or dirt.

STEP 2 Apply OVERcoat Final Touch TRIM to the applicator and spread it evenly on the surface.

STEP 3 Let it sit for 1 to 2 minutes and gently remove the excess with a dry microfiber cloth.

OVERcoat Final Touch TRIM

OVERcoat Final Touch

・Content: 100ml (3.38oz)

・Durability: Approx. 2 months

・Accessories: Applicator


Shipping & Tax Included



Do not drink. If ingested, do not induce vomiting. If the liquid gets into your eyes, rinse immediately with water. If you feel nauseous during use, stop using it immediately. Seek medical attention if any abnormalities occur. Store out of the reach of children in a cool, dark place. Effects may vary depending on the surface. The product may undergo discoloration, but this does not affect its effectiveness. Never use it for any other purpose. If it comes into contact with the bodywork or glass, wipe it off immediately with a dry cloth. Do not use in direct sunlight, windy days or on a hot vehicle surface. The use of protective gloves is recommended. Wash your hands thoroughly after use. OVERCOAT JAPAN is not responsible for any injuries caused by incorrect and improper use of the product. Read this carefully before using this product. Composition: Polyacrylic resin, propanediol, resin, fragrance.

Frequently Asked Questions (FAQ)

Q. How long does it take to cure?

A. Curing time is approximately 2 to 3 hours.

Q. Is surface preparation necessary before application?

A. The effect will be better if you prepare the surface.

Q. How often does it need to be applied?

A. It depends on factors such as the environment and how often you use your car. It is safe to reapply when the plastic trim becomes dull.

Q. What kind of applicator can it be applied with?

A. It can be applied with microfiber, sponge applicators or detailing brushes.

Q. What kind of surfaces can it be used on?

A. Windshield wiper resin area, front grille, fender arches, door frames, bumpers, side mirror resin parts, etc.

Q. How long does it last?

A. It typically lasts for about 2 months.

Q. Where should it be stored?

A. In a cool and dark place, out of the reach of children.

Q. Does discoloration occur?

A. The product may undergo discoloration, but this does not affect its effectiveness.

Where To Buy