It can be used for cleaning, polishing compound application, and applying coatings, waxes, and other products. Check the intended use and precautions for the product being applied, and use the appropriate side for each task.

The white synthetic microfiber side can be used for cleaning and spreading polishing compound across the application surface.

The gray microfiber side can be used to spread coatings, waxes, and other products across the application surface.

It can be used to apply polishing compound to vehicle bodywork. Check the instructions for the compound being used and test it on an inconspicuous area before proceeding.

It can be used with polishing compounds specifically designed for glass, such as OVERcoat GLASS RESET. Use only products intended for use on glass and follow their instructions.

It can be used for both interior and exterior vehicle cleaning. However, as it may not be suitable for certain materials or surface conditions, check the compatibility of the product being used and test it on an inconspicuous area first.

Be careful not to drop the applicator on the ground. If this happens, do not continue using it. Wash it immediately with cold or lukewarm water, and carefully check that no sand, soil, or other debris remains before using it again.

Use on all types of materials is not guaranteed. Check the type and condition of the surface, and follow the precautions provided for the product being used.

Using the applicator when sand or hard debris is attached, or applying excessive pressure, may scratch the surface. Check the condition of both the applicator and the application surface before use.

Avoid using it on areas with scratches, cracks, peeling, or deterioration. If you are unsure about the condition of the surface, test it on an inconspicuous area first.

To prevent different products from mixing, we recommend using separate applicators for each product or purpose. This product includes two applicators.

The amount required varies depending on the product used and the size of the application area. Follow the quantity and directions for use specified for each product.

This depends on the product being used. Follow the product’s directions regarding whether the application surface should be wet or dry.

After use, rinse the applicator with cold or lukewarm water to remove product residue and dirt. Rinse thoroughly to ensure that no residue from the products used remains.

Use a neutral liquid laundry detergent or OVERcoat pH+ alkaline car shampoo. pH+ helps remove oils and product residue from the fibers. After washing, rinse thoroughly to ensure that no detergent or dirt remains.

Hand wash the product to help prevent deformation or damage. Do not use a washing machine, dryer, or iron.

Keep the applicator out of direct sunlight and allow it to dry completely in a well-ventilated, shaded area. Store it only after it is fully dry.

Do not store the applicator while it is wet or while product residue remains. After washing, make sure it is completely dry before storing it.

There is no fixed replacement period based on the number of uses. Stop using and replace the applicator if you notice fiber shedding, deformation, tears, or dirt that cannot be removed.

The applicator does not completely prevent contact with the product. Wear protective gloves when necessary. If the product comes into contact with your hands, follow the precautions provided by the manufacturer.

Store in a clean, dry place away from direct sunlight, high temperatures, humidity, heat sources, and open flames. Keep out of reach of children.