OVERcoat pH+

Recommended for removing oily film, insect residue, grease, tar, and other dirt from the body. Used as a pre-wash, it helps loosen dirt before hand washing, making it easier to remove.

Dilute in a spray bottle, apply to the entire car, wait about 2 minutes, then rinse thoroughly with a pressure washer or a strong stream of water.

OVERcoat pH-

Recommended for water spots, mineral contamination, rain stains, road salt, and salt residue from coastal areas. It can be used as a pre-wash and applied either before or after an alkaline shampoo, depending on the condition of the vehicle.

For heavier mineral-based contamination, such as after driving near railways, coastal areas, or snowy roads, dilute the product in a sprayer, apply it over the entire vehicle, and let it dwell for about 2 minutes. Then rinse thoroughly with a pressure washer or a strong stream of water.

If the vehicle has already been pre-washed with an alkaline shampoo, it is also recommended to apply the product with a foam gun, covering the entire vehicle with foam, and then proceed directly to a hand wash using OVERcoat Neutral pH.

OVERcoat Neutral pH

A neutral shampoo used after loosening dirt during the pre-wash. With rich foam and high lubrication, it helps reduce friction during contact wash and lowers the risk of fine scratches.

Dilute in a foam gun, foam spray, or bucket. Apply foam to the entire car, wash from the roof down to the lower sections, and rinse thoroughly at the end.

OVERcoat ULTRAviolet

A foam ceramic coating that can be used on the wet body after washing. It spreads easily over the entire car and helps prevent streaks or uneven application.

Dilute in a foam gun or foam spray and apply to the entire car while it is still wet. Wait about 2 minutes, then rinse thoroughly. When using it with a bucket, apply it section by section and rinse each area right away before the product dries. Finally, dry the entire car thoroughly so no water droplets remain on the surface.